| •
|
Removal of the airbag must be performed
according to the precautions/ procedures described
previously. |
| •
|
Before disconnecting the front impact
sensor connector, disconnect the front airbag
connector(s). |
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the front
impact
sensor. | |
| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Disconnect the front impact sensor
connector.
|
| 3. |
Remove the front impact sensor mounting
bolt. |
| 4. |
Remove the front impact
sensor. |
| •
|
Do not turn the ignition switch ON and
do not contact the battery cable while replacing the front
impact
sensor. | |
| 1. |
Install the new front impact
sensor. |
| 2. |
Tighten the front impact sensor mounting
bolt.
Tightening
torque
: 7.0 ~ 9.0 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~
6.6 lb.ft)
| |
| 3. |
Connect the front impact sensor
connector. |
| 4. |
Reconnect the battery negative
cable. |
| 5. |
After installing the Front Impact Sensor,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
